Page 1 of 1
ID Ford part found in drawers.
Posted: February 26th, 2019, 10:56 am
by Astrodokk
Been going through the rig finding stuff in drawers and cubbies.
Found this Ford part.
Does anyone know what it goes to?
Re: ID Ford part found in drawers.
Posted: February 26th, 2019, 11:14 am
by sm350bl
looks like a fuse/relay cover for the aux distribution panel that holds the trailer lighting fuses. is there any fuses/relays visible under the hood? if so see if that cover fits over it.
Re: ID Ford part found in drawers.
Posted: February 26th, 2019, 11:15 am
by Blue~Go
Ooh, good one. I don't recognize it. Is one of those little numbers a part number you could Google? I find there is usually on one a Ford piece. Oftentimes they start with something like FDUZ or the like.
Re: ID Ford part found in drawers.
Posted: February 26th, 2019, 1:10 pm
by chin_k
There is a ford part number under the Ford label. I can't read it well, but it looks like some kind of cover like sm350bl said.
Re: ID Ford part found in drawers.
Posted: February 27th, 2019, 8:12 am
by sm350bl
Most of the times on pieces like that, I find its just an engineering number and not the true part number.
Re: ID Ford part found in drawers.
Posted: February 27th, 2019, 8:49 am
by Blue~Go
Certainly does look like something that would click into place and cover something else. As mentioned, I'd check under the hood (maybe near the big fuse block there) or under the dash. Would be nice if someone just recognized it though!
Re: ID Ford part found in drawers.
Posted: February 27th, 2019, 11:33 am
by chin_k
According to the following page that I found with the id/part/engineering number on it, it is a fuse box cover, like one of you guys guessed.
http://www.2040-parts.com/99-04-mustang ... rt-i10828/
Here is the comparison:
Re: ID Ford part found in drawers.
Posted: February 27th, 2019, 12:31 pm
by Astrodokk
Since I had time today, I punched in the number seen under the Ford logo on eBay, and sure enough it’s a cabin fuse box cover.
I tried putting it back in, but there is so much wiring harness stuff under there that it’s hard to do. Leaving it out won’t harm anything, but I jammed it under some wires so it doesn’t get lost.
Re: ID Ford part found in drawers.
Posted: February 27th, 2019, 9:05 pm
by Blue~Go
That's too funny. I've had that thing off and on any number of times, but didn't recognize it. For some reason the photo had me thinking it was like 2" square, which is much smaller than the fuse box cover.
I might be thinking of something from my Blue Sea house bus, but I think there might be a set of clips on the front side for holding a pair of those fuse tweezers.
I have had to curse a couple of times getting it to clip back on just right, so maybe that's why it was in a drawer. Or maybe someone added some fuse taps and then it wouldn't fit?